Many Cardiff homes have a rear extension that is gloomy because it only has one window. A flat roof gives you the chance to bring daylight straight down from above. In most cases a roof light can be added, either while the roof is being renewed or into an existing roof. The detail around the opening is what matters most.
Short answer and what it depends on
Usually yes. A flat roof can take a fixed rooflight, an opening one, a glazed lantern or a long strip of glass, provided the structure can carry it. What changes the answer is the span of the joists, the size of the opening you want, and the condition of the deck and covering around it. On a roof that is already near the end of its life, we normally advise renewing the covering and fitting the light together.
Why an upstand is non-negotiable
Water must never be allowed to sit against the glazing. A roof light is mounted on a raised kerb, called an upstand, formed from timber and insulated so the glass sits clear of the roof surface. The waterproof covering then turns up the sides and tucks beneath the light's frame. This kerb is what keeps the opening dry in a heavy Cardiff downpour. Skipping it, or making it too low, is the commonest reason roof lights leak.
Cutting into the structure
Cutting an opening means interrupting one or more joists, so trimmers are fitted around the hole to carry the load. In a Victorian or Edwardian terrace extension we check the old rear wall and the joist sizes first. A large lantern is heavier than a small flat pane and needs more support. If the opening affects the main house wall or the neighbour's side, we raise that with you early. It may need planning or Building Regulations checks, and we advise before work starts.
Choosing the type that suits the room
The right light depends on how the room is used. Think about heat, glare, ventilation and cleaning as well as appearance, because a south-facing kitchen extension behaves very differently from a shaded utility room. We talk through the options on site, with the extension in front of us, and check the joist layout before anything is ordered. Points we cover with you are listed below.
- Fixed, opening or vented, and where a pole or motor would sit
- Glazing that limits summer heat and winter heat loss
- Size relative to the room and the joist layout
- Who can reach it safely for cleaning from inside
- Whether it suits a garage, kitchen, hallway or porch
Fitting it into an existing roof
Cutting into a finished roof is possible but needs care, because the new covering around the opening must be tied into the old one without a weak seam. On EPDM we bond in new sheet; on GRP we laminate a fresh section; on felt we build up new layers around the kerb. We assess which route suits your roof before quoting the work.
Get a Free Flat Roof Quote in Cardiff
Flat Roofing South Wales provides free, no-obligation quotations in Cardiff and the surrounding area.
Call 07766 547309More Flat Roof Guides for Cardiff
Flat Roof Questions Answered
Will a roof light make my Cardiff flat roof more likely to leak?
Not if it is fitted on a proper raised upstand with the covering turned up and lapped correctly. Leaks happen when the kerb is too low or the edges are poorly sealed. Done well, a roof light is a long-term, watertight part of the roof.
Can a roof light go into a garage flat roof as well as an extension?
Yes, garage roofs can take one too, provided the structure beneath can support the opening. Garage joists are sometimes lighter than extension joists, so we check the timber sizes and the condition of the deck before agreeing the size and position.
Is it better to fit the light when the roof is renewed?
Often yes. The new covering can be formed around the kerb as one continuous layer, so there is no joint between old and new. If your roof is sound, we can still add a light later, but it depends on the existing covering.