EPDM Rubber Roofing › Port Talbot
EPDM is a single-ply synthetic rubber membrane, laid in one sheet where the roof size allows and bonded to a sound deck with adhesive. It has fewer joints than felt, which matters on flat roofs sitting under driving rain off Swansea Bay. It suits small and medium roofs of many shapes. Either way, we explain the choices before starting.
We take care over the edge trims, upstands and corner details, because that is where flat roofs tend to fail. We also look at the deck, the falls and the insulation before laying anything. For wider flat roofing work, see our Flat Roofing South Wales section. Either way, we explain the choices before starting.
Call 07766 547309 about epdm rubber roofing in Port Talbot, or message us on WhatsApp.
EPDM on Port Talbot Flat Roofs
Port Talbot has a lot of interwar and post-war housing with flat-roofed garages, rear extensions, porches and bay tops added over the decades. Many of these have old felt that has cracked or blistered. Replacing it with EPDM is a common job for us, particularly around Sandfields and Baglan. It is a straightforward swap once the deck is checked.
Wind off the bay lifts at flat-roof edges, so trims and upstands need to be properly fixed and bonded. Rain also runs along flat roofs in a way it never does on pitched ones, so drainage and falls matter. We check that water has somewhere to go before laying anything. We would rather confirm that than assume it.
Older terraced houses near Aberavon and Taibach sometimes have small rear flat roofs over kitchens or outhouses. These are awkward to reach but suit a single sheet well. We assess the deck condition first, and if it has rotted we say so and explain the repair. The extra care is worth it on a roof you cannot easily see.
EPDM Jobs We Do in Port Talbot
- Garage roofs in EPDM — We strip tired felt from garage roofs and lay a bonded rubber sheet with proper edge trims and a sound drainage fall.
- Extension and porch roofs — Rear extensions and porches get a single sheet where possible, with careful upstands against the house wall and clean corner details.
- Dormer flat roofs — Small dormer flats are tricky to detail, so we take time over the corners, cheeks and upstands to keep water out.
- Deck repairs and new decks — If the existing deck is soft or damaged we repair or replace it first, because EPDM needs a sound surface to bond to.
- Insulation and drainage checks — We look at falls, outlets and insulation before laying the membrane, since poor drainage causes most early flat-roof trouble.
- Patch repairs on sound membrane — Where an existing EPDM roof is sound, we can patch and cure small damage instead of recovering the whole roof.
How We Lay EPDM in Port Talbot
We begin by checking the deck, the falls and any insulation, and measuring so the membrane can go down in as few pieces as possible. Garages and extensions in terraced streets often have limited access, so we plan how materials get to the roof and explain it to you first.
We bond the sheet to the deck, then form the edges, upstands and corners by hand. Afterwards we check the outlets and trims and talk you through what we have done. If we find rot or poor falls on the way, we stop and tell you before carrying on.
EPDM Rubber Roofing Guides for Port Talbot
EPDM Rubber Roofing in Port Talbot — Common Questions
What is EPDM and why use it on a Port Talbot garage?
It is a single-ply rubber membrane bonded to the deck, with fewer joints than felt. On a garage exposed to wind and rain off Swansea Bay, fewer joints means fewer places for water to find a way in.
Can EPDM be laid over my old felt roof?
Sometimes, but usually we prefer to strip the old covering so we can check the deck underneath. If the deck is sound and dry, options exist. We look first and tell you which route makes sense for your roof.
Does the deck matter for an EPDM roof?
Yes. The membrane is bonded to the deck, so the deck must be sound, dry and flat. Rotted boards cause trouble later. We check the deck, the falls and the insulation before laying anything.
Can a leaking EPDM roof be repaired?
If the membrane is sound, small damage can often be patched and cured. If the sheet has failed more widely, a full recover may be better. We inspect it and explain which applies. We explain it first.
Do you do EPDM on dormer and porch roofs?
Yes. Small dormer flats and porches suit a single sheet well, though the corners and upstands need care. We detail them by hand and check the water has a clear path away. We explain it first.
More Roofing Help in Port Talbot
Nearby Towns
Contact T&T Roofing in Port Talbot
We cover Port Talbot and the area around it including Aberavon, Sandfields, Taibach, Margam, Baglan.
Tell us what the roof is doing in Port Talbot and we will look at it. Call 07766 547309, message us on WhatsApp or use the form below.